The RESTCONF server provides access to specific datastores using operation resources, however, the RESTCONF protocol does If a RESTCONF server is co-located with a NETCONF server, then there are protocol interactions with the NETCONF protocol. The kind of functions that can be performed by NETCONF and RESTCONF APIs. YANG-A data modelling language that is used to model configuration and operational features. RESTCONF- Uses structured data (XML or JSON) and YANG to provide a REST-like APIs, enabling you to programmatically accessĭifferent network devices. This section describes the protocols and modelling languages that enable a programmatic way of writing configurations to a Long story short DO NOT USE IOS XE 16.6.1.Protocols and Data Models for Programmatic Device I was able to boot again and log in than I did :Īnd to be sure I reloaded and did a wr erase after that and another reload. RECOVERY_BUNDLE=sda9:cat3k_caa-recovery.binīoot manually the switch which fails to boot: You will see outout like below (values may vary) here is the sollution to get your switch out of the boot loop : So for future reference if any ony finds this. The other switch is available, and I had a succesfull setup with VSS but again with an unknown reason I found this morning the switch in a continues boot.Īs the IOS is recent, I cannot find anything on the web how to solve this issue (VSS is a recent added option to this hardware platform) so any tips on completely factory default my 3850XS or removing / bypasing the VSS stack election would be great ! Switch refuses to do anything else than looping with the message above. I have tried to boot without the startup config (as used in the password recovery), and many other things including the full emergency recovery which erases the boot flash: but no success. Octeon_wdt: WDT device closed unexpectedly. Switch rebooted continously for atleast 5 times. Oct 2 14:08:18.652 FP0/0: %PMAN-5-EXITACTION: Process manager is exiting: reload fp action requested Waiting for 120 seconds for other switches to bootĬhassis 2 reloading, reason - Active/standby selection failed in 1+1 Mode During a setup of my new cores (2 x 3850 XS switches) running IOS XE 16.6.1 in VSS mode due to an unknown reason one of my switches keeps rebooting after switch election with the following message :
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |